Maintenance; Continuous Inspection And Maintenance Of The Device; Cleaning; Change Flash Tube - Walimex Pro Newcomer 100 Manual De Instrucciones

17. Maintenance

17.1 Continuous inspection and main-
tenance of the device
Inspect all cables and plugs for damage
WARNING
Danger of electric shock and danger of
fire due to short circuit.
Have the device repaired by an electrician
immediately.
Please load the flash capacitor as required
(see "Loading the flash capacitor").

17.2 Cleaning

WARNING
Posterior danger of bursting of flash
tube
Make sure not to touch the flash tube with
bare hands accidentally.
WARNING
Danger of electric shock
Just use the specified cleaning supplies.
Do not bring the device into contact with
moisture or water.
Disconnect from power supply during
cleaning.
NOTE
Don´t clean the modeling bulb and flash
tube with water. Even small residues on the
bulbs could lead to bursting
Part of the Cleaning
device
Housing Use a microfiber cloth to
remove light and stubborn
dirt.
Modeling bulb, Wipe off with dust brush
flash tube or dry, soft cloth
Reflector Remove dirt with
microfiber cloth
17.3 Change flash tube
WARNING
Please just use flash tubes, which are
conform with the required specifications as
to avoid the bursting of the flash tube. See
Technical Specifications.
WARNING
Posterior danger of bursting of flash tube
Don´t touch the flash tube with bare hands.
Wear clean cotton gloves or use a clean
cloth.
2
3
1
1 Flash Tube
2 Retention Clip
3 Socket for modeling lamp
43