Technical Informatio; Functions - Marklin Digital 60940 Manual Del Usuario

• Operate the decoder only with the authorized voltage
(see technical data).
There is a danger of burning yourself when working
with a soldering station.
Technical Information
• Dimensions (L x W x H) 30 x 15.5 x 6.2 millimeters
• Continuous current load at the motor output ≤ 1.1 amps
• Current load at the light outputs ≤ 250 milliamps
• Current load at AUX 1 – AUX 2 each ≤ 250 milliamps
• Current load at AUX + lights (total) ≤ 300 milliamps
• Current load for motor and AUX 5/6 ≤ 1.1 amps
• Maximum total load ≤ 1.6 amps
• Maximum voltage ≤ 40 volts
• Sound performance (at 4 Ω /8 Ω) 2.3 watts / 1.2 watts
• Short circuit and overload protection at the outputs
„Front Light(s) (LV), „Rear Light(s) (LH), AUX 1 – AUX 2
and at the motor outputs.

Functions

These instructions describe the installation and possibilities
for settings on the 60940 decoder. Unless otherwise speci-
fi ed, the functions refer to this decoder.
The mSD SoundDecoder is a sound decoder with very
extensive setting and adaptation possibilities. Additional
sound functions are available. This decoder can be updated.
The requirement for this is an appropriate controller
(60213/60214/60215 Central Station, software Version 2.0,
track format processor GFP 2.0 or higher).
The settings and digital functions can only be used in digital
22
operation. However, the same possibilities are not available
in all protocols.
• C apable of multi-protocols (fx (MM), mfx, DCC, and AC/DC).
• Automatic system recognition. The address assigned to
each system must be used for operation.
• Acceleration and braking delay can be set separately
from each other. Any function button desired can be as-
signed using the function mapping.
• Typical sound backdrops for diesel and electric locomo-
tives are included.
• Variable motor feedback control is available in digital as
well as in analog operation.
• This decoder supports the 6090, 60901, DC, Sine, and mo-
tors with bell-shaped armatures. Note the table on Page 22.
• Funktionsmapping, siehe Hilfe in der Central Station
60213/60214/60215 oder eine ausführliche Tabelle zum
Funktionsmapping fi nden Sie im Internet unter:
www.maerklin.de/de/produkte/tools_downloads/tech-
nische_infos.html
• Can be updated with the CS2 (Software 2.0, track format
processor GFP 2.0 or higher).
• Programming on the Main (PoM) this type of program-
ming must be supported by the controller. Please note
the instructions for your controller when doing this.
• Switching range can be set.
• Braking / signal stopping block recognition is available in
digital operation.