Moen PureTouch INS115D El Manual Del Propietario página 13

OPERATING INSTRUCTIONS
Battery Replacement cont'd
NOTE: When reinstalling screws and filter outlet
nut, insert into hole, turn counter clockwise with
screwdriver until a click is felt then turn
clockwise until snug. DO NOT OVERTIGHTEN!
11. Reinstall 2 short and 1 long upper housing screws until snug. Refer to picture
(7&11) on previous page for placement of long screw. DO NOT OVERTIGHTEN!
NOTE: To assist in aligning lower housing, press side buttons
slightly while sliding housing in place.
12. Reinstall lower housing by carefully aligning over button covers.
13. Reinstall two short lower housing screws until snug. DO NOT OVERTIGHTEN!
14. Reinstall filter outlet nut (21) with flat screwdriver. DO NOT OVERTIGHTEN!
15. Insert filter by aligning outlet tubes with inlet ports on main pullout spout
assembly and gently pushing in and down. Upon successful installation of
filter cartridge, pullout spout will emit a series of three beeps and filter life
indicator will reset automatically.
16. Reinstall filter cover by positioning alignment
tab over corresponding notch in main pullout
spout assembly and gently pushing in and
down.
17. Reattach quarter turn connector (18) to pullout
spout (19) aligning the dots on the quarter
turn connector and the spout. Push the quarter
turn connector onto the spout assembly and
turn it clockwise, locking it in place. Return
spout to the receptor.
18. If new filter was not installed at battery change, refer
to remaining filter life previously recorded at
beginning of battery replacement. Subtract recorded
number in step 1 from the 100% displayed. The
difference represents the display setting at which
the current filter will need replacement. Filter may
not perform as desired after this calculation percentage.
Example: Remaining filter life prior to battery change equals 30%.
Subtract 30% from 100% (100 - 30 = 70).
Filter will need to be changed when indicator reads 70%.
HELPLINE: 1-800-BUY-MOEN
INS115D
(8)
(16)
(17)
ALIGN
DOTS
12