Care And Maintenance - Moen PureTouch INS115D El Manual Del Propietario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

MICROTECH™ FILTER INSTALLATION

NOTE: Faucet will not operate in any mode without filter. Filter should be left in

protective bag until ready for installation. The MicroTech™ filter is a high

performance carbon block filter developed specially for the PureTouch Filtering

Faucet System. Once the filter is installed in the pullout spout, it should not be

removed until it is to be replaced. The electronic module keeps track of the

amount of filter life remaining and will signal you when the filter change is

necessary. If a partially used filter is removed and reinstalled, the electronic

indicator will automatically reset and will not accurately reflect filter life

remaining.

Use only MicroTech filter cartridges with the PureTouch Filtering Faucet System

1. Remove the filter cover by lifting it up and away

from the pullout spout body.

2. Insert the new filter by aligning the outlet tubes

on the filter with the inlet ports of the spout

body and gently pressing in and down. Upon

successful installation of the filter cartridge, the

filter life indicator will beep three times and

reset automatically. (Do not remove the filter

until it is to be replaced.)

3. Reinstall the filter cover by positioning the

alignment tab with the corresponding notch in

the main pullout spout body and gently

pushing in and down.

4. Attach the pullout spout to the hose by

aligning the dots on the quarter turn connector

(18) and the spout. Push the quarter turn

connector onto the spout assembly and turn it

clockwise, locking it in place.

5. Allow cold water to run through the new filter

for 5 minutes to flush out any loose carbon

particles. (See page 9 for filtered water mode.)

Once these small black particles are washed

out the filter is ready for use.

The PureTouch System installation is now complete. Please read carefully the

operation instructions to ensure optimal performance.