Symbole; Installation; Spezifikationen - PEUGEOT Energysaw 254DB Instrucciones De Utilizacion

25. Use the blade guard at all times.
26. The lower blade guard must always be in place and in good working order.
27. Always keep hands away from the blade path.
28. Never reach around or behind the blade.
29. Make sure the blade is not touching the cut piece before switching the tool on.
31. Important: After the cut, release the switch and wait until the blade stops turning before bringing the head back up.
32. The use of accessories not recommended by Delta France may cause injury.
33. Make sure the blade has completely stopped before moving or tightening the cut piece, changing the angle of the piece
or changing the angle of the blade.
34. Never cut ferrous metals or masonry.
35. Never crop small pieces.
36. Provide proper support on each side of the saw table for long pieces.
37. Never use the mitre saw in a place where there are flammable liquids or gases.
38. Never use solvents to clean plastic parts. Solvents can dissolve or damage the material. Use a damp cloth to clean plastic
parts.
39. Disconnect the saw from the power supply before carrying out maintenance or changing blades.
40. Disconnect the saw from the power supply and clean the machine after use.
41. Make sure that the work area is clean before leaving the machine.
42. If the saw is missing a part, is damaged or defective, or if an electrical part is not working properly, switch it off and un-
plug it from the outlet. Replace the missing, damaged or defective part before reusing the saw.
43. Keep these instructions. Refer to it often and use them to inform other users.
25