Mondolfo Ferro TB125 Manual De Uso página 57

WARNING
Make sure that the gripper is well attached
to the rim.
4) Move the control console to working
position B.
5) Position the tyre on the platform and lower
the turntable (making sure to keep the gripper
in the highest point) to hook the first bead to
the gripper.
6) Lift the rim with the tyre hooked to it and
turn it anticlockwise about 15-20 cm. The tyre
will be positioned tilted across the rim.
7) Move the tool holder arm to the non-working
position; move it to the inner side of the tyre
and rehook it in this position.
8) Make sure that the hook tool is positioned
to the side of the wheel.
Otherwise, press the tool rotation lever and
turn it 180°.
9) Move the control console to working
position D.
10) Move the tool forward so that its red refer-
ence dot is aligned with the external edge of
the rim, 5 mm. away from it (see Fig. 30).
- E - User Manual TB125
nglIsh
11) Move the control console to working
position C.
29
12) Move to the outside of the wheel and visu-
ally check the exact position of the tool and
adjust it as needed. Then turn the turntable
clockwise until the gripper is at the lower
point (6 o'clock).
The first bead is now in the rim.
Remove the gripper.
13) Move the control console to working
position D.
14) Remove the tool from the tyre.
15) Move the tool holder arm to the non-
working position; move it to the outer side
of the tyre.
16) Turn the tool 180° using the tool rotation
lever.
17) Move the control console to working
position B.
18) Turn the turntable until the valve hole is
at the lower point (at 6 o'clock).
19) Move the mobile platform under the wheel
and lower the turntable until the turntable
rests on the platform.
Move the platform outward to create space
between the tyre and the rim into which the
inner tube can be inserted.
30
57