TYROLIT Hydrostress FSE1240 Serie Instrucciones De Servicio página 44

TYROLIT Hydrostress AG
8 Malfunctions
Malfunction
Saw blade jammed
Saw blade does not rotate even
though the motor is running
Feed not working
Electric motor does not run
Page 20
Possible cause
Saw blade is jammed in the cutting material
Belt tension too slack
Pulling pin on the anchoring flange has
sheared off
Operation of the control rods impaired
Defective hydrostat
Defective chain
Main motor belt slipping
EMERGENCY STOP switch has been pressed.
Not plugged in to mains
Defective cable
Faulty electric motor
Wrong direction of rotation
Solution
► Reverse the floor saw.
► If necessary release the saw blade by
rocking.
► If necessary stop the motor, disassemble
the saw blade and release this
individually from the cutting material.
► Tension or replace belt.
► Mount new anchoring flange.
► Check control rods and arrange repair as
necessary.
► Check hydrostat and if necessary have
this repaired by a TYROLIT Hydrostress
engineer.
► Have the chain replaced by a TYROLIT
Hydrostress engineer.
► Check belt for wear and if necessary
have this replaced by a TYROLIT
Hydrostress engineer.
► Increase belt tension as necessary.
► Release EMERGENCY STOP switch.
► Plug in to mains
► Check cable and change as necessary.
► Have electric motor checked by a
qualified electrician.
► Note rotary field warning lamp
► Shift forward / reverse switch
Floor Saw FSE1240