●
leaving the product unattended
●
cleaning your product
●
changing accessories
●
clearing blockages
●
checking for any damage after hitting an object
●
checking for any damage if the product starts to
vibrate abnormally
●
performing maintenance
WARNING
Never use cutting means or attachments which are not
specifi ed by Ryobi in this manual. This includes the use
of metal multi-piece pivoting chains and fl ail-blades.
These items are known to break up during use and
present a high risk of serious injury to the operator or
bystanders.
WARNING
Inspection after dropping or other impacts:
Thoroughly inspect the product and identify any
affections or damage with it. Any part that is damaged
should be properly repaired or replaced by an
authorised service centre.
GRASS TRIMMER SAFETY WARNINGS
■ Replace the string head if cracked, chipped, or
damaged in any way. Be sure the string head is
properly installed and securely fastened. Failure to do
so can cause serious injury.
■ Avoid using on wet grass.
■ Do not walk backwards when using the product.
■ Walk, never run.
■ The small blade fitted to the cutting attachment guard
is designed to trim the new extended line to the correct
length for safe and optimum performance. It is very
sharp; do not touch it, particularly when cleaning the
product.
■ Always ensure that ventilation openings are kept clear
of debris.
■ Before use and after any impact, check that there
are no damaged parts. Examine the cutting means
for signs of cracking or other damage. A defective
switch or any part that is damaged should be properly
repaired or replaced by an authorised service facility.
■ Make sure the head attachment is properly installed
and securely fastened.
English (Original instructions)
■ Make sure all guards, deflectors, handles, bolts, and
■ Do not modify the product in any way. This may
■ Use only the manufacturer's replacement line in the
■ Never operate the product without the cutting
■ Maintain a firm grip on both handles while trimming.
TRANSPORTATION AND STORAGE
■ Stop the engine and allow it to cool down before
■ Clean all foreign materials from the product.
■ Drain all fuel from tank into a container approved for
■ Run the engine until it stops, this will remove all fuel
■ Store the product in a cool, dry, and well-ventilated
■ When transporting the product in a vehicle, secure
■ Never carry or transport the product while the engine
■ Abide all government and local regulations for the
Short term
■ Stop the engine, and allow it to cool down before
■ Clean all foreign material from the product.
■ Store the product in a cool, dry, and well-ventilated
■ Keep away from corrosive agents such as garden
■ Do not store outdoors.
18
fasteners are properly and securely attached.
increase the risk of injury to yourself or others.
cutting head. Do not use any other cutting attachment.
attachment guard in place and in good condition.
Keep string head below waist level. Never cut with
the string head located over 76 cm or more above the
ground.
storing or transporting.
petrol. Remember to properly replace and tighten the
fuel cap.
that could become stale and leave varnish and gum
in the fuel system.
place that is inaccessible to children. Keep away from
corrosive agents, such as garden chemicals and de-
icing salts. Do not store outdoors.
it against movement or falling to prevent injury to
persons or damage to the product.
is running.
safety storage and handling of petrol.
storing.
place that is inaccessible to children.
chemicals and de-icing salts.