Tabla de contenido
Publicidad
2.0
Installation - Rotary Actuators / Installation Actionneurs rotatifs / Instalación Actuadores
giratorios
2.0
8
2.1
Mechanical Installation - Rotary Ac-
tuators
The positioner is mounted on to the top surface of the pneu-
matic actuator using an appropriate mounting kit.
The positioner's mounting configuration is to the VDE/VDI 3845
standard, if the actuator is to the same standard, a standard
NAMUR mounting kit can be used, otherwise a special
mounting kit will have to be obtained.
Assuming the installation will use the standard NAMUR
mounting kit, proceed as follows:
1. Fix the bracket to the top surface of the actuator using the 4
screws provided.
2. Locate the positioner in place on top of the bracket, making
sure that the 4 mm. tongue locates properly into it's slot in
the actuator spindle.
3. Fix the positioner to the bracket using the 4 screws provided.
DOC,F20,EFS Rev.: -
Publicidad
Tabla de contenido
