Prepare Boiler For First Startup; Controller Stop Mode - Rendamax R3 EVO Serie Manual De Uso E Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Commissioning

Prepare boiler for first startup

Legend:
A On/off switch
B Return (ESC)
C Room temperature control
D Confirmation (OK)
E Manual mode
F Chimney sweeper mode
G Info mode
H Reset button
I Operation mode heating zone(s)
L Display
M Operation mode DHW

Controller Stop mode

For setting the controller stop mode
K
and insert setpoint press (
K
Press (
) >3 sec. again for setting
combustion parameters.
Display (L)
Info mode (G)
Display possibility of following info
without influence on boiler control:
temperatures, operation mode Heating
/ DHW, error code.
Confirmation (OK) (D)
Return (ESC) (B)
These buttons are used for
programming in combination with the
wheel.
By pressing the ESC button it is
possible to go back one level, changed
values are not taken over by the
controller.
By pressing the OK button it's possible
to arrive in the next level or confirm
changed values.
Manual mode (E)
This button is used for switching the
boiler into manual mode. In manual
mode all pumps will run and the mixing
valves are no longer controlled, the
burner setpoint is adjustable (60°C
factory setting) (indicated by spanner
symbol).
M
H
On/off switch (A)
Position 0:
) > 3 sec.
Boiler and connected electrical
components are not powered. Frost
protection is not secured.
Position I:
The boiler and connected electrical
components are powered and standby
for operation.
Deaeration mode (E)
By pressing the manual mode button
longer than 3 seconds, the automatic
hydraulic deaeration is activated.
During deaeration the system is put
in standby mode. The pumps are
switched on and off for several times.
After deaeration, the boiler
automatically returns to normal
operation.
Chimney sweeper mode (F)
Used for combustion analysis. By
pressing the button once again,
or automatically after 15 minutes,
the chimney sweeper mode will be
deactivated (indicated by spanner
symbol).
Reset button (H)
By shortly pressing the reset button a
burner lockout can be cancelled.
b
c
0
4
6
12
16
20
24
-
+
ESC
OK
B
C
D
E
I
L
G
F
A

Publicidad

Tabla de contenido
loading

Tabla de contenido