Maintenance; Trouble Shooting; Technical Data; Nail Range - Senco Smart BoardMaster Instrucciones De Empleo

MAINTENANCE

Warning
y Repairs other than those described here should be
performed only by trained, qualified personnel. Contact
SENCO for information at:
+31 320 295 575.
y Read section titled "Safety Warnings" before maintaining
tool.
y Only use spare parts specified by manufacturer or
authorized representative.
y
All screws should be kept tight. Loose screws result in
unsafe operation and parts breakage.
y Check monthly
y With tool disconnected, make daily inspection to assure
free movement of workpiece contact and trigger. Do not
use tool if workpiece contact or trigger sticks or binds.
y Squirt Senco pneumatic oil (5 to 10 drops) into the air
inlet twice daily (depending on frequency of tool use).
Other oils may damage O-rings and other tool parts.
y Some Senco tools are Oil Free and DO NOT require oil,
Check label.
y Wipe tool clean daily and inspect for wear. Use non-
flammable cleaning solutions only if necessary.
y Do Not Soak.
y Caution: Such solutions may damage O–rings and other
tool parts.
y
Dispose of cleaning materials properly.

TECHNICAL DATA

Tool Type
XtremePro Series
SBM SCN49XP 6-8,3 bar
SBM SCN65XP 6-8,3 bar

NAIL RANGE

Tool Type
Min-Max diameter mm
XtremePro Series
SBM SCN49XP 2.1-2.9
SBM SCN65XP 2.5-3.3
111 3/8 in NPT 3
270 3/8 in NPT 8
Min-max length mm
Smooth Ring
32-65 32-60
50-90 50-70
9

TROUBLE SHOOTING

SYMPTOM
Air leak near top of tool. / Sluggish operation
1
SOLUTION
Verify air supply / tighten screws or install Repair
Kit – See Parts Manual
SYMPTOM
Air leak near bottom of tool / Poor return.
2
SOLUTION
Clean tool / tighten screws or install Repair Kit
See Parts Manual
SYMPTOM
Other problems.
3
SOLUTION
Contact SENCO.
SYMPTOM
No illumination on Display.
4
SOLUTION
Check Battery Level, charge if required.
10.2 375 337 - 1173
11.4 275 337 - 1173
Screw Collation Type
50-65 Wire & Plastic
50-83 Wire
Should Staple Jam Occur:
Disconnect Air Supply
Remove Fasteners
Clear the Jam
Follow loading Procedure
337-1283 314
337-1283 327
Collation Angle
16°
16°
EN