Descargar Imprimir esta página

FREEWIRE FW295 Manual Del Usuario página 21

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 43
position.
Base doesn't ring: Probably base ring mode is disable, change the base ring melody;
When you press a key the cordless will connect the phone line and some numbers are displayed:
Direct (emergency) call activated - Press faster 2 times
key;
On telephone near the base of the cordless I listen some noise: Displace the base away of 20-30cm.
respect the previous position;
Noise during conversation: Displace the base away of 20-30cm. respect the previous position;
Handset doesn't turn on: Remove and replace the batteries, pay attention at the polarity, USE ONLY
RECHARGEABLE BATTERIES AND NOT ALKALINE BATTERIES;
Receiver/speaker volume low: Adjust the volume level and/or pay attention to not cover or put label
on the receiver/speaker hole;
Hands free: To get a good conversation on hands free we suggest to avoid to speak caller/called all
together but one each time and use hands free mode on room with lower background noise.
R (FLASH) key doesn't transfer the call on my switchboard (PABX): Flash key of FW295 is on 100ms
may be not compatible with your switchboard.
Caller identifier doesn't work: Be sure that the caller identifier service was subscribed with your
Telephone network provider.
SMS doesn't work: Be sure that the SMS service is available from your Network provider, change the
Service Center number with the Service Center of your network provider.
Technical data
Technology: DECT Standard (Digital European Cordless Telephone) with GAP (Generic Access
Profile) profile RF Channels: 10 Channels; Frequency range: 1.881 Ghz ~ 1.897 GHz - Channel
Bandwidth: 1.728 MHz
Speech encoding: ADPCM / 32 Kbps ; Modulation type: GFSK ; Output power: 250mW max
Battery life: stand-by: about 120 hours; talk: about 12 hours
Communication range: about 500 mt in open field; about 100 mt in closed field
Power supply for handset: Ni-MH Batteries (AAAx2, 2.4V, 550 mAh)
Power supply for base set: DC6V 200mA - Recharging time: 12 hours
Dialing method: DTMF ;
Max handset to the base: 5 (4 + 1 in endowment) - Max base to the handset: 4
Declaration of Conformity
I-TECHSWISS Group addressed inch.des croisettes 26, 1066 Epalinges -CH <info@i-
techswiss.com -www.i-techswiss.com> declare that this product is conforms with the essential
requirements and provisions of the 1999/05/EC Directive regarding the radio equipment and
telecommunications terminal equipment and the mutual recognition of their conformity.
On the basis of this declaration, these products and the packaging will bear the
following mark:
.
This equipment also complies with the essential requirements and provisions from Low Voltage
Directive 73/23/EC and EMC directive 89/336/EC, and also complies with those standards EN301406
V.1.4.1; EN301489-01 V.1.3.1; EN301489-06; EN60950:2000. The complete CE Declaration of
Conformity is available at: I-TECHSWISS Group inch.des croisettes 26, 1066 Epalinges -CH.
EN

Publicidad

loading

Productos relacionados para FREEWIRE FW295