Delta ShopMaster MS450 Manual De Instrucciones página 10

MOVING TABLE TO THE 0° CUT-OFF
POSITION
1. Loosen locking knob (A) Fig. 6 by turning counter-
clockwise. Depress lever (B) and rotate table (C) to
the 0° straight cut-off position, release lever (B), and
tighten locking knob (A).
2. Fig. 7 illustrates the table (C) in the 0° straight cut-off
position.
3. For proper operation and adjustment of the table,
refer to sections, "ROTATING TABLE FOR MITER
CUTTING", and "ADJUSTING SLIDING FIT
BETWEEN MOVABLE TABLE AND BASE."
ATTACHING THE EXTENSION WINGS
This machine uses two table extension wings to help
support long or wide workpieces. To attach the wings:
1. Slide the stop block (A) Fig. 7A onto one wing (as
shown in Fig. 7A) and thread a wing screw (B) Fig. 7A
and (11) Fig. 2 into the hole on the side of the stop
block.
2. Tighten wing screw (B) Fig. 7A.
3. Insert extension wing rods (C) Fig. 7A into holes in
outer wall of saw as shown in Fig. 7A.
4. Thread wing screw (F) Fig. 7A into clamp bracket (E)
as shown. Place clamp bracket over hole (D) and
slide extension wing rod (C) through the clamp
bracket (E). Be sure other extenson wing rod (C) is
inserted through hole (G).
5. Tighten thumb screw (E) Fig. 7B.
NOTE: The right extension wing is installed the same
way.
C
B
C
E
F
E
10
B
A
Fig. 6
C
Fig. 7
A
G
D
Fig. 7A
Fig. 7B