Delta ShopMaster MS450 Manual De Instrucciones página 11

ATTACHING THE FENCE SLIDE
1. Position the sliding fence (E) Fig. 7C, on top of saw
fence slide support(J). Install thumb screw (K) and
set screw (L) but do not tighten at this time.
2. Slide fence (E) on fence slide support (J) Fig. 7D.
Tighten set screw (L) with hex wrench (M) until it
contacts the fence slide support, then loosen one
turn. The purpose of this set screw is to prevent the
sliding fence from coming completely off the slide
support.
IF SET SCREW (L) IS LEFT TIGHT THE
SLIDING FENCE WILL NOT MOVE.
3. Slide fence to the desired position and tighten thumb
screw (K).
ATTACHING THE WORK CLAMP
Install work clamp assembly (F) Fig. 7E into desired
mounting hole (G). Assemble thumb screw (H) but do not
fully tighten at this time.
MAKE SURE THAT FENCE (M) Fig. 7F
AND WORK CLAMP
GUARD AND BLADE (L) Fig. 7F BEFORE OPERATING
SAW.
ATTACHING DUST BAG
Depress spring clips (A) Fig. 8, of dust bag (B) and clip
dust bag (B) over rib of dust chute.
B
(N) Fig. 7F ARE CLEAR OF
A
Fig. 8
J
K
J
K
G
N
11
L
Fig. 7C
M
Fig. 7D
F
Fig. 7E
M
L
Fig. 7F
E
E
L
H