Commissioning; About The Module; Module Height; Guide Plate - Festo MPS Descripción Breve

Programming module

13 Commissioning

13.1 About the module

The modules of the MPS

Fully assembled

Functionally aligned

Pre-commissioned

Tested
Note
When used in MPS
have to be changed.

13.2 Module height

The module height can be adjusted depending on the area of application. Simply loosen the mounting
screws, move the module to the required height and tighten the mounting screws again.
When combined with an MPS
chamfer up on the module easily. This ensures a smooth sequence.

13.3 Guide plate

The guide plate must be adjusted so that the EasyKit is tensioned during positioning so that it is not blocked
during rotation.

13.4 Slide

A fine adjustment of the press-on and slide-out position can be carried out through the two elongated holes
on the slide.
It must hereby be observed that the slide is not fastened at an angle; otherwise, a collision with the drive
roller may occur.
62

are generally delivered

stations, the mechanical setup, as well as sensor positions and settings, may

module conveyor, the height must be adjusted so that the EasyKit slides the
© Festo Didactic 8046514