Replace Plug Connector - Festo MPS Descripción Breve

14.1 Replace plug connector

Dismounting
– Move the cylinder to the lower end position
– Switch off the compressed air and power supply
– Carefully unplug the flat cable from the programming plug
– Unscrew and remove the two mounting screws
– Carefully remove the defective plug connector from the mounting
Mounting
– Carefully position the new plug connector in the mounting
– Mount the plug connector on the metal sheet with the screws
– Carefully insert the flat cable into the programming plug while observing its alignment
© Festo Didactic 8046514
Programming module
65