fortress V Serie Instrucciones De Instalación página 30

5. If needed, use shims to level the posts.
6. Clamp panel to post in 4 places.
7. Place marking for panel cuts at the back of bracket
opening. As shown in Fig. 2 below.
8. Use speed square to ensure markings are perpendicular to
panel.
Note:
• Place panel Midspan Supports as close to inside of post as
possible.
• Be sure panel is fully raked when marking panel cuts.
• Be sure cable hardware does not interfere with brackets
when marking the panel.
Fig. 1
Step 2: Cut & Clean Rails
1. Cut rails using a saw with a ferrous metal cutting blade.
2. Use file to smooth cut edges.
3. Remove any metal shavings and dust with a brush or rag.
4. Make sure surfaces to be painted are clean.
Note:
• Be sure not to cut Grommets in rails.
Fig. 1
30
Fig. 2
Post To Baluster
Space Must Be
Less Than 4"
[102mm]
Fig. 2
V-SERIES: VERTICAL CABLE INSTALLATION
Mark on rail
from back
of bracket
Post To
Baluster
Space Must
Be Less Than
4" [102mm]
Fig. 3