fortress V Serie Instrucciones De Instalación página 9

• Remove all metal shavings from deck, post base cover,
post, and panel before bracket is screwed to
post to prevent rust stains.
Fig. 1
Pre-drill Dimensions: Pre-drilling with a 3/16"[5mm] drill bit is required
A*
34" [864mm] Panel
4-1/16" [103mm]
40" [1016mm] Panel
4-1/16" [103mm]
*Dimension A positions bottom edge of rail 3-3/4" [96mm] above deck surface.
*Dimension A is measured from the bottom surface of post base.
Fig. 2
B
C
B
Step 2: Pre-Drill and Install Brackets
Tip:
• It's important to double check dimensions to confirm
accuracy of bracket hole locations before drilling.
1. Use Spring Punch to mark the holes. As shown in Fig. 1.
2. Pre-drill bracket holes with a 3/16" [5mm] drill bit.
As shown in Fig. 2.
3. Attach Bracket to the posts with supplied T-25
thread-cutting screws. Use two screws per bracket. Use
low speed setting on drill. As shown in Fig. 3.
4. Once top and bottom brackets are installed, remeasure
bracket spacing to confirm dimensions used in Fig. 2 and 3
of step 1. As shown in Fig. 4.
UB-05 Bracket Hole Locations
B
5/8" [16mm]
5/8" [16mm]
B
A
D
V-SERIES: VERTICAL CABLE INSTALLATION
C
36-15/16" [938mm]
42-15/16" [1090mm]
A
D
5/8" [16mm]
5/8" [16mm]
9