Special Cleaning Of Tube And Filter; Tube Blow-Dry Function - NUK BP7 First Choice Manual Del Usario

10520xxx_Rev400_GA_NUK Mipu Tischpumpe BP7.book Seite 29 Donnerstag, 5. April 2018 12:52 12
can damage the electrical contacts and
cause deformation.
• Incorrect treatment can damage the
parts.
• Before using again, allow the sterilised
parts to cool and dry completely before
reassembling.
• Only use water
sterilisation:
1. Use a NUK Steam Steriliser, following the
operating instructions of the device.
Alternatively,
2. sterilise the parts in boiling water for 5
minutes.
Ensure there is sufficient water in the pan
to avoid damage.
Alternatively,
3. use a NUK Micro
Microwave Steam
sterilisation in your microwave oven.
• Only use the NUK Micro Express Plus
Microwave Steam
microwave sterilisation.
operating instructions of the device.
5.3 Special cleaning of tube
and filter
1. If milk enters the tube 4, switch the
device off immediately.
2. Dismantle the device as shown in figure B,
proceeding in reverse from 7 to 1.
3. Remove the filter 6 (see figure C).
4. Clean the following parts with lukewarm
water and a little washing-up liquid and/
or NUK Rinsing Agent:
– rinse filter 6 ;
– flush tube 4 with tube connector plug 7.
5. Reassemble according to figure C or B in
reverse order and then use the blow-dry
function (see "5.4 Tube
function" on page 29) of the device to dry
the tube 4 and the tube connector plug 7.
Note: Since the filter 6 would be a virtually
impermeable barrier while wet or damp, it
would inhibit the blow-dry function and the
pump suction. Insert the dry replacement
filter instead. Leave the freshly cleaned and
rinsed damp filter to air-dry for at least
4 hours.

5.4 Tube blow-dry function

1. Assemble the device as shown in figure B.
and steam for
2. To start the blow-dry function press the
3. Check that the tube is completely dry (no
Express Plus
Steriliser for
Steriliser for
Follow the
4. To stop the blow-dry function, switch the
blow-dry
29
Do not insert a filter that is still damp, but
use a dry replacement filter instead.
master power switch
simultaneously touch the buttons
and 25.
The blow-dry function runs for 5 minutes.
droplets visible inside), before starting
the next pumping session.
If the tube is not yet completely dry, start
the blow-dry function again.
You can pause the blow-dry function by
touching the Pause button
continue it later by touching the Pause
button 25 again.
pump unit off by pressing the master
power switch 26.
26 and then
22
25 and