Display Messages; Operation Guide; Preparation; Turn On Or Turn Off - Baxtran SUPER SS Serie Manual De Usuario

User's Guide

2.2 DISPLAY MESSAGES

dc x.xx
Mean the voltage of battery is x.xx V.
Show this as the weight over 100% FS+9e, with the ding sounding, this means over load, reduce
------
the weight.
AdC
As the A/D change overflowing, display shows this with the ding sounding.
-BAtLo- The voltage is lower. You can use a short while and charge immediately.
C End
Recharge is end.
_
Err-0
Loadcell bad connected or A/D error
Err-1
Calibration switch placed at OFF during calibration
Err-2
No enough sample (on piece counting mode)
Err-3
Calibration weigh too small

3. OPERATION GUIDE

3.1. PREPARATION

Adjust the base foot, watch the level, make the pan in horitzontal.

3.2. TURN ON OR TURN OFF

3.2.1. Turn on:
Press the ON/ 0 key, the ding sound, it displays version No. and the battery voltage level and 9, 8,
7, ..., 1, 0, the " 0". led lighting. Now the scale is in a working state.
3.2.2. Turn off:
Long-press OFF key.
3.2.3. Auto-off:
After 10 minutes in zero, scale will auto-off.
3.2.4. Low voltage auto-off:
When the voltage lower than 5.6V, then power-off.

3.3. ZERO

When without taring the weight display is ≤ 4% Max. capa., press the ON/ 0 key, the display shows "0",
the 0 led lighting.

3.4. WEIGHING

Put weight to pan.

3.5.TARE WEIGHING

Press the T key, the weight display is "0", the
display is negative, the

3.6. SAVE POWER FUNCTION

Zero after 40 seconds, auto save power, shows "o". Put a weight start weighing.

3.7. BATTERY INDICATE

Battery led:
voltage lower than 6V.
12
0 lighting, press the
means voltage higher than 6.3V,
Top Loading scale
0 led off, the Tled lighting. Pick up the weight, the weight
T key, the T led off.
means voltage between 6V and 6.3V;
Model Super SS
means