Charge; Set Parameter - Baxtran SUPER SS Serie Manual De Usuario

Model Super SS

3.8. CHARGE

Power supplied by a internal rechargeable lead acid battery (6V/4Ah). When it shows "-bAtLo-". Please turn off
and charge immediately. The time of full charging is 12 - 14 hours.

3.9. SET PARAMETER

Press SET/0~9 key 3 seconds to set. Now show menu. Press SET/0~9 sequentially it displays:
rAngE (set limit)
UnIt5 (choose unit)
A-OFF (choose auto power off)
FILt (display filter)
2ero (set auto
0)
bU22Er (set buzzer)
d (choose division)
d-dP (choose single or dual display)
3.9.1 Set range of auto-zero
When it shows "rAngE", press
exit, press T to confirm.
When choose "on" and press
SET/0~9 once to increase the current digit, press
when you press
and set "over" after setting into weighing.
When low limit > high limit, it displays "oFF", then exit.
Caution: when the display is not stable, no led lights.
Alarming indicate: if bu22er parameter is set to on, alarm will sound if the weigh over the pan is on ok zone.
3.9.2 Change Unit
When it displays "UnIt5", press
Unit: x9 (kg), pc5 (piece counting), lb. l b (lb), Lb. o 2 (lb.oz), 9 (g).
Counting: when it displays "pc5" press
and return to 0. Then put the sample and press
which sample comprises. After finishing it displays "pc5" and "
Exit counting: choose unit.
Caution: Pick quantities of Max less 30000.
3.9.3 A-oFF (choose auto power off)
When menu displays A-oFF, press
"y" means, after 10 minutes in zero, auto-off.
3.9.4 Change display filter:
When it displays "FILtX" (FILt1 means one step change display, FILt2 means 3-4 steps change display, FILt3 means 6-8
steps change display) Press SET/0~9 to change, press
3.9.5 Set range of auto-zero:
When it displays 2ero, press
5d. "d" is the division value when n=3000). Press SET/0~9 to choose and
Top Loading scale
T and then SET/0~9 to choose "on" or "oFF", "on" is start the function, "oFF" is
T, now you will weigh with limit; led "-"(under limit) lighting, first digit is blinking, press
T, led "+" turns on, then you can config upper limit with the same procedure; when finishing auto exit
T, then press SET/0~9 to choose, then press
T. Now "
T to enter, press SET/0~9 to choose "n" o "y", "n" is not auto power off,
T, now shows 2ero x.x (x.x is the range: 0.5d, 1d, 1.5d, 2d, 2.5d, 3d, 3.5d, 4d, 4.5d,
T to confirm and edit next digit; once you finish to set all "-" digits,
" led lighting. Press longtime ON/ 0, it displays count
T. Press SET/0~9 and press
" led lighting.
T to confirm and exit.
T to confirm.
User's Guide
T to confirm and exit.
T input the quantity of pieces
13