31
40°C
16:30
1
32
3
CLEANING ON
TIME 10
16:30
2
2
~4 "
PLEASE
EMPTY
THE BATH
TIME 00
16:30
Disinfection of the
water circuit
I Make sure that the outlet nozzles on the walls of the tub are
open (chapter on preliminary operations, fig. 8. The dorsal
nozzles are always open).
I Fill the tub (with no one in it) until covering
lets. The same water used for the hydromassage can be used,
possibly adding the amount required to reach the necessary
level.
I Make sure that the disinfectant liquid, provided with the tub,
has been poured into the appropriate tank.
Jacuzzi suggests using "Actisan Bath" disinfectant liquid
(available from authorized service centres) and running the
cycle about once a month (if the tub is used privately).
NOTE
• The opening for the tank is located under the headrest and
is closed with a plug (chapter on preliminary operations, fig.
9). The tank contains more than a litre.
Starting up with the remote control
I Turn on the remote control by pressing the
display will show the Jacuzzi logo and moving bubbles.
• If the remote control is not used for about 1 minute, the display
panel light gradually fades until it goes out; press any button to
start it again.
I (fig. 28) Then press the
icon for the sanitizing function.
I While aiming the remote control at the receiver, as shown
in the figure, hold the
The sanitizing cycle will start, while the display will show the
indicated screenshot and the LED on the receiver on the edge
of the tub comes on.
At the bottom of the display, you can also check the duration
of the cycle (10 minutes, which counts down to zero)
• The cycle is carried out in sequence as follows: when the
cycle starts, the pump is started, and it aspirates and places
in the circuit a predetermined amount of disinfectant liquid.
After about two minutes, the pump starts and then starts again
automatically during the last minute of the cycle.
94
(optional system)
the dorsal out-
key: the display will show the
key down for about four seconds.
key: The