Kit Assembly - Metra 99-5831 Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Attach the pocket to the radio brackets using
the (4) #8 x 3/8" Phillips screws supplied.
(Figure A)
2. Remove the metal "DIN" sleeve and
trim ring from the aftermarket radio.
3. Mount the radio to the radio brackets using
the screws supplied with the radio. (Figure B)
4. Snap the hazard switch into the radio trim
panel from the front.
5. Snap the A/C vents into the radio trim panel
from the back.
6. Plug in the passenger airbag light and
hazard connections.
7. Locate the factory wiring harness and
antenna connector in the dash, and complete
all necessary connections to the radio. Metra
recommends using the proper mating adapter
from Metra and/or AXXESS.
8. Attach (4) panel clips to the radio trim panel,
and then reassemble the dash in reverse
order of disassembly, using the 99-5831
radio trim panel.

Kit Assembly

(Figure A)
(Figure B)
99-5831
ISO DDIN radio provision
1. Attach the radio brackets to the radio
using the screws supplied with the radio.
(Figure A)
2. Snap the hazard switch into the radio
trim panel from the front.
3. Snap the A/C vents into the radio trim
panel from the back.
4. Plug in the passenger airbag light and
hazard connections.
5. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS.
6. Attach (4) panel clips to the radio trim
panel, and then reassemble the dash in
reverse order of disassembly, using the
99-5831 radio trim panel.
3
(Figure A)