Mounting Head Assembly - Fanimation Punkah Manual Del Propietário

INSTALLATION NOTE
The following illustrations serve as a guide on mounting
and securing your motor assembly either to the ceiling
or to the wall. Building structure designs will vary
depending on the local building codes. Be sure of your
layout plans before fastening your fan head unit.
▲WARNING
To reduce risk of personal injury, do NOT mount the fan
unit into (dry) wall or ceiling board only.
1. Locating head assemblies; head assemblies need to be
17˝ (minimum) to 48˝ (maximum) distance from motor
assembly or other head assembly.
2. Secure the fan unit base to wall or ceiling into building
structure using the two lag bolts and fl atwashers provided.
Figure 10
3. Install the blade holder assembly by rotating it into place
through the slot of the base. Figure 11
4. Set the blade holder assembly to the desired angle (10°
increments up to 30° max - wide oval blade; 45° max -
narrow oval blade) tighten the base mount screw in the
side of the base. Figure 12

Mounting Head Assembly

8
Figure 10
Figure 11
Figure 12