Assembly; Installing The Receiver - Home Decorators Collection 51472 Guía De Uso Y Cuidado

Assembly - Hanging the Fan (continued)
6
Setting the remote control codes
NOTE: The frequencies on your receiver and remote control have
been preset at the factory. Before installing the receiver, make
sure the dip switches on the receiver and remote control are set
to the same frequency. The dip switches on the remote control
are located inside the battery compartment.
NOTE: This remote is equipped with a 16-code combination.
To prevent possible interference from or to other remote units,
such as garage door openers, car alarms, or security systems,
change the combination code, but be sure that the code on
both the hand held transmitter and receiver in the fan are the
same.
NOTE: The switch marked ON/DIM controls the dimming
function of the lights: If using CFL bulbs, use a ballpoint pen
or small screwdriver to set the switch to ON to disable the
dimming function. If using standard bulbs, set the switch to
DIM to enable the dimming function.
To set the code on the remote control:
□
Remove the battery cover by pressing firmly on the ar-
row and sliding the cover off.
□
Slide the code switches to your choice of either up or
down. The factory setting is up.
□
Install a 12-V battery (included) into the remote control.
□
Replace the battery cover on the remote control.
To set the code on the receiver:
□
Slide the code switches to the same position as set on
your remote control.
Controller Model: MR101D
ON
ON 【 】 *
ON DIM
1 2 3 4
12V 23A
ON
ON
DIM
1 2 3 4
1
7

Installing the receiver

□
Position the receiver (K) flat side up and perpendicular to
the slide-on mounting bracket (A).
□
Position the supply wires to the left side of the slide-on
mounting bracket (A), and position the fan wires to the right
side.
□
Partially insert the receiver (K) flat side up until one end
rests on the ball/downrod assembly (B).
A
*
【 】
2 3 4
9
WARNING: To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring must
meet all local and national electrical code requirements. The
electrical source and fan must be 110/120 volt, 60Hz.
CAUTION: If other fan wires are a different color, have this unit
installed by a licensed electrician.
K
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
B