3M 3320030 Manual Del Usuario página 19

Inspection Date:
Components: Inspection:
Self-Rescue System Inspect the Harness Interface. Ensure the Locking Pin (A) is fully seated (Red Warning Ring is
Figure 15 not visible) and both Locking Buttons (B) are engaged.
Inspect the Easy-Link D-Ring (C) for damage, corrosion, and proper working condition.
Inspect inside the Easy-Link D-Ring opening (D) to ensure the lifeline termination is in good
condition and the Latch Fuse (E) has not been broken from previous deployment.
Inspect the Descent Device Housing (F) through the Front Flap (G) for distortion, cracks, or
other damage. Verify that the Red Rope Exit Seal (H) is in place.
Open the Back Zipper (I) far enough to validate the Lifeline (J) is dry, undamaged, and properly
spooled.
;
On the Self-Rescue TRAINING System, some discoloration and fraying of the
lifeline rope is expected after multiple descents (Figure 14). As long as strands of
the rope are not completely severed, the TRAINING System can remain in use for
up to 20 descents (see Appendix A).
Open the Hook and Loop Flap (L) on the side of the Backpack and verify that the Assisted
Rescue Cable (M) is properly seated in the in the slot on the Connector Side Housing Clip (N).
Inspect the Assisted Rescue Handle (O) to ensure that it is correctly positioned with the handle
protruding out the side of the Backpack.
All labels must be present and fully legible (see "Labels").
Full Body Harness
Inspect the Full Body Harness per the manufacturer's instructions.
Lanyards and
Inspect Lanyards and Self-Retracting Devices per the manufacturer's instructions.
Self-Retracting
Devices
Serial Number(s):
Model Number:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
sales@bestmaterials.com | http://www.bestmaterials .com
sales@bestmaterials.com | http://www.bestmaterials .com
sales@bestmaterials.com |
sales@bestmaterials.com | http://www.bestmater ia ls.com
Distributed by Best Materials® LLC
Table 3 – Inspection and Maintenance Log
Inspected By:
(See Section 1 for Inspection Frequency)
http://www .bestmaterials.com
http://www .bestmaterials.com
http://www.bestmaterials.com
Date Purchased:
Date of First Use:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
| 1-800-474-757 0
| 1-800-474-757 0 | 1-800-474-757 0
| 1-800-474-757 0
| 1-800-474-7570
| 1-800-474-7570
Competent
User Person
1