Connections To Be Made - Axxess GMOS-LAN-02 Instrucciones De Instalación

Attention! This vehicle may come equipped with a digital amplifier. Ensure that the
factory radio was removed with all settings in their default positions.
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an ASWC-1 (sold separately), there will be an accessory wire
there to connect as well.
• Connect the Blue/White wire to the amp turn on wire. This wire must be
connected to hear sound from the factory amplifier.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• If the aftermarket radio has a mute wire, connect the Brown wire to it. If the
mute wire is not connected, the radio will turn off when OnStar is activated.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
GMOS-LAN-02

Connections to be made

The following (3) wires are only for multimedia/navigation radios that require these wires.
From the GMOS-LAN-02 harness to the aftermarket radio:
12-pin pre-wired ASWC-1 harness:
Backup camera harness (if applicable):
2
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• The Black/Yellow wire is used for OnStar level adjustment for models that
do not come equipped with steering wheel controls. Refer to the OnStar level
Adjustment section for further instructions.
•
This harness is to be used along with the optional ASWC-1 (not included) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.
Note: The relay attached to the GMOS-LAN-02 harness is only for audible turn signal
clicks. No extra steps are required to retain this feature, so leave the relay as-is.
• If retaining the factory backup camera, connect the Yellow RCA jack to the
backup camera input of the aftermarket radio.