Start Up; Rinse Aid Dispenser Operation; Detergent Dispenser Installation; Electrical Connection - Blakeslee UC-19 Instrucciones Para La Instalación, Uso Y Mantenimiento

USA

1.10 Start up

Start up the dishwasher and carry out any calibration of the detergent dispenser:
1) Turn the wall switch on and open the water valve.
2) Switch the dishwasher on, pressing the key
3) The machine starts to fi ll with water (important: do not open the door).
4) At the end of boiler fi lling, rinsing starts, to complete the tank fi lling. After fi lling, the dishwasher starts heating the boiler
and tank.
5) The machine is ready for washing.
N.B.: If the water valve is closed or the fi lling time is too long, the dishwasher may go on tank fi lling time-out
(programming parameter B) indicating fault code 3.

1.11 Rinse aid dispenser operation

A
Functioning:
to load a spring.
D
The release of the spring generates the suction of the rinse-aid chemical from its container to the
C
B
boiler.
To prime the rinse-aid pump, run some wash/rinse cycles.
Adjustment:
code 10799/G
pict. 1
This quantity is adjustable from 0 to 0,24 cubic inches (from 0 to 4 cm³), equivalent to circa 0 to 11
inches (from 0 to 30 cm) length of the suction hose.
Turn the adjustment screw clockwise to reduce capacity.
Turn the adjustment screw anticlockwise, to achieve the maximum capacity (up to 20 turns).
THE DISPENSERS ARE PRE-SET TO A 2" (5 CM) INTAKE OF PRODUCT FOLLOWING A TEST PHASE SYSTEM
CHECK. THIS MEASUREMENT SHOULD BE ADJUSTED ACCORDING TO THE TYPE OF RINSE AID USED AND WATER
HARDNESS.

2. DETERGENT DISPENSER INSTALLATION

2.1 Electrical connection

Follow the wiring diagram attached to the machine.

2.2 Pipe connection

a) Remove the cap from the hole and fi t the delivery connection.
b) Correctly mount the injector
c) Connect the suction tube to the suction attachment of the dispenser (see pict. 3 - point A).
d) Connect the delivery tube to the other attachment of the dispenser, and the delivery fi tting (see pict. 3
point B).
e) Insert the tube with fi lter in the detergent tank.
f) Prime the detergent and proceed with the dosage phase.
pict. 2
C
Point B
min 1" 1/4
(3 cm)
B
A
CONNECTION DIAGRAM
page 34
INSTALLER SECTION
B (see chap. 3). The reletive green LED lights up.
The dosing pump is powered by the pressure generated by the rinse pump, used
The dosing pump takes a determined quantity of rinse-aid chemical at each rinse.
C using the appropriate fi xtures.
pict. 3
2.3

Dosage

The detergent dispenser delivery can be adjusted by directly operating
with a screwdriver as shown in pict. 2.
Every 13 / inches (2 cm)
16
inches (0,25 cm³), equal to
cubic inches - 1,2g/cm³). Also see par.
of product drawn corresponds to
0,01 once (0,3 g) (with density 0,70
15.2.
1 / cubic
64
once/