Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USA
5. MACHINE PROGRAMMING
This section applies to the electronic version.
N.B.:
the conventional cycle version is fi tted standard with a fl owswitch that controls the presence of supply water and with
which, entering programming, a constant consumption of water in the rinse phase can be defi ned regardless of the supply
pressure.
To enter programming:
•
press the keys
A
and
B
the message
Key
will be displayed
•
set the value of the password to
•
confi rm the password pressing the key A; if the password is correct the parameter choice will be accessed, otherwise
the message
Err
will be displayed for about 4 seconds.
N.B.:
to enter programming the machine must not be washing; if you try to enter programming during washing, the message
no Pr
will be displayed and the dishwasher will continue the cycle.
The machine will automatically exit programming if no key is pressed for about 20 seconds.
5.1 Parameter choice
On entering parameter choice the message
P (P1, P2, ...
PJ).
At this point it will be possible to:
•
select the number of the parameter to be modifi ed by pressing the keys
•
enter programming of the parameter selected pressing the key
•
exit programming pressing the key D.
5.2 Parameter programming
On entering parameter programming the message
At this point it will be possible to:
•
change the parameter value with the keys
•
confi rm the value and go to programming of the next parameter, by pressing the key
•
return to the parameter selected without changing the data by pressing the key D.
The following parameters can be changed (see table 2 on the next
page 36
INSTALLER SECTION
at the same time, making sure to lightly press the key
15
ilwith the keys
P
will be displayed; press the key
P
and the parameter number followed by the parameter value are displayed.
▲ B
and
▲ B
and
▼ C
A
▲ B
A
▼ C
page):
B
fi rst, for about 5 seconds, after which
repeatedly to defi ne the parameter number
and
▼ C
A
Publicidad
Capítulos
Tabla de contenido
