Adjusting The Tone(Bass And Treble) - Sherwood RX-4109 Instrucciones De Funcionamiento

.
6
To mute the sound.
.
7
To listen with the headphones.

Adjusting the tone(bass and treble)

.
8
Enter the tone mode.
.
9
At the desired tone mode, adjust the tone as desired.
.
10
To listen to a program source without the tone effect.
•"MUTE" lights up and flickers.
•To resume the previous sound level, press this
button again.
•Be sure to switch off both A and B speakers.
•Each time this button is pressed, the corresponding
tone mode is selected and shown for 3 seconds as
follows:
→ BASS → TRBL
Note:
•When the tone direct function is activated, the tone
mode cannot be entered and "TON DIR" flickers for
3 seconds.
•If the tone display disappears, start from the step
8 again.
•When pressing the TREBLE UP/DOWN(∧/∨ )
or BASS UP/DOWN(∧/∨) buttons, you need not
select the desired tone mode on the step 8.
Notes:
•Extreme settings at high volume may damage
your speakers.
•In general, the bass and treble levels are adjusted
to 0.
•"TON DIR" is displayed, "DIRECT" lights up and
the sound that bypasses the tone circuitry will be
heard.
•To cancel the tone direct function, press this
button again to display "TON CTRL", and then
"DIRECT" goes off.
11