Tuning To Preset Stations; Scanning Preset Stations In Sequence - Sherwood RX-4109 Instrucciones De Funcionamiento

Tuning to preset stations

.
1
After selecting the tuner as an input source, select the preset mode.
.
2
Select the desired preset number.
Listening to FM stereo broadcasts

Scanning preset stations in sequence

• Then "PRESET" lights up.
• When using the NUMERIC buttons on the remote
control.
Examples) For "3"
For "15" :
For "30" :
• When selecting the desired preset number with the
NUMERIC buttons, the desired preset station will
be tuned to automatically without selecting the
preset mode.
• While listening to FM broadcasts, press the FM
MODE button.
• Each time this button is pressed,
the FM mode changes as follows:
→ Stereo mode : "ST" lights up.
Mono mode : "ST" goes off. ←
• When FM stereo broadcasts are poor because of
weak broadcast signals, select the FM mono mode
to reduce the noise, then FM broadcasts are
reproduced in monaural sound.
• The receiver will start scanning the stations in the
preset sequence.
• At the desired station, press this button again to
stop scanning.
14
: