Step 4 - Rear Basket Tube Assembly - Foundations LX3 Instrucciones De Montaje Y Uso

STEP 3 - Front Wheel Assembly (continued)
5.
While holding bearing on front wheel post, position
Front Wheel Assembly (D) so bearing race is facing
front wheel post and bearing inside Front Wheel
Assembly is on opposite side, slide Front Wheel
Assembly onto front wheel post and bearing
(Fig. 3).
6.
Slide Lock Washer (L) and Flat Washer
(M) onto M6 x 25 mm Shoulder Screw (K)
and then insert screw into bottom of front
wheel post and tighten securely (Fig. 4).
Repeat steps 2 thru 6 to assemble
front wheel on other side of stroller.

STEP 4 - Rear Basket Tube Assembly

1.
Position Rear Basket Tube (G) with curved
bend pointing down (Fig. 1).
2.
Secure the Rear Basket Tube onto the stroller by
sliding the ends of the Rear Basket Tube onto the
tubes at the side of the stroller frame until the ends
contact the spring buttons (Fig. 1).
3.
Press the spring buttons
Tube onto the tubes
into the holes in the Rear Basket Tube (Fig. 2).
4.
Pull out on the Rear Basket Tube to check that
it is securely attached
5.
Attach fabric basket to Rear Basket Tube.
- Unsnap snaps on fabric basket, wrap fabric
basket over the top of the basket tube and
reattach snaps on fabric basket (Fig. 3).
Lock Washer
and slide the Rear Basket
1
until the spring buttons lock
2
3 (Fig. 2).
Bearing
Race
Flat Washer
Shoulder Screw
Rear Basket
Tube
Curved
Bend
Snaps
Fabric
Basket
Rear Basket
Fig. 3
Bearing
Fig. 4
Fig. 1
Fig. 2
2
3
1
Fig. 3
6
Tube