Using The Unit - SPORT-ELEC SPORT PRO Manual Del Usuario

STEP 6 : End of program - Stopping
At the end of the session, the screen proposes to start a new session by blinking the front muscles to select
the 1st muscle zone. Restart the starting procedure if you wish to continue on another muscle zone.
Otherwise, press the
The unit switches to standby after 5 minutes idle.
Recommendations :
The pictograms for upper muscles and for lower muscles are different. Avoid selecting upper muscles and
lower muscles, as the unit would give priority to upper muscles, reducing somewhat the yield of work on
lower muscles.
III. Using the unit
A / ELECTRODES FUNCTION
This function allows using the adhesive electrodes by connecting them to the unit
STEP 1 : Take the electrodes and remove carefully their protection, dampen them one by one with water
on your fingertips on the adhesive gel, and wait for 2 minutes (diagram I-A, page 2).
STEP 2 : Fit the electrodes on your body as shown in diagram II-A or B or C page 2 : Positions are shown
for information only
Locate the electrodes according to the program chosen.
Important: for optimum use, read each page carefully, and take the examples of use
into consideration (photos II page 2).
Examples of use :
B = connector channel B (blue), C = connector channel C (orange)
A - Chest
1 - Large chest
a - Do not place the
electrodes close to the heart
b - Heart
STEP 3 : Take connector (CEV4 or CEV8 according to the model) (photo I-B page 2) and connect it :
1° - to the electrodes (photo I-C page 2)
2° - then to the unit (photo I-D page 2).
STEP 4 : The unit is connected to the electrodes through the CEV4 connector, made of 4 (or 2) groups of 2
1m-long wires terminated by 2 groups of 2 connecting terminals.
Fasten your SPORT-ELEC
key to stop.
B - Shoulders
2 - Medium deltoid
3 - Posterior
4 - Anterior
SUP : upper limbs - INF : lower limbs
to the back of your clothing or underwear using its clip.
®
C - Trapezius
9 - Upper trapezius
10 - Medium trapezius
- 23 -