SPORT-ELEC SPORT PRO Manual Del Usuario página 18

STEP 5 : Start your unit following the "Starting the unit" procedure described in paragraph II.
Contractions should be firm but never painful. If you feel an unpleasant sensation around the electrodes : bring the
power-on key back to minimum, move the electrode(s) and gradually increase the power. Once the adjustments
have been optimised in this way, leave your appliance to work for the full duration of the programme.
STEP 6 : Once the program is complete, disconnect the electrodes from the (CEV4 or CEV8) connector, then
the latter from the unit. Then pull off the electrodes gently, dampen them slightly with a few drops of water,
then return them carefully onto their support. Store the adhesive electrodes in a fresh location, in a plastic bag
(e.g. vegetable container in the refrigerator).
B / BELT FUNCTION
The multifunction belt can be used completer, or separated into 2 to form 2 half-belts.
The full belt must be used on the stomach, buttocks, lower back areas.
Once unfastened, the 2 "half-belts" can be used on the arms, thighs, or calf.
The multifunction belt has built-in electrodes on which the SPORT-ELEC
This cream enhances contact between the electrodes and the skin. Its massaging and electro conducting
properties improve comfort of use and enhance stimulation. The cream can be also used by massaging on
the body. If you want to buy the SPORT-ELEC
00.33.2.32.96.50.50 or go to www.sport-elec.com, or contact your local supplier.
You may not use the belt without the cream provided.
Do not use any cream other than that provided by SPORT ELEC
PRESENTATION OF THE BELT :
• Front side : (photo III-A page 3)
1 - Central fasteners
• Electrodes side : (photo III –B page 3)
4 built-in electrodes
STEP 1 : Connecting and fitting the belt
1 - Check your SPORT-ELEC
2 - Take the (CEV4 or CEV8) connector (photo I-B page 2) and connect it :
• 1° - To the belt connectors per groups of colour (e.g. yellow terminals with yellow terminals,
green terminals with green terminals...) (photo III - C page 3).
• 2° - Then to the unit (photo III - D page 3).
3 - Apply a thick layer of electro conducting massaging cream onto the zone chosen then onto the electrodes
built into the belt (domed part - photo III - E page 3)
4 - Place the belt or 2 half-belts onto the zone(s) to be stimulated, and adjust them using "scratch" strips to
ensure the built-in electrodes are properly in contact with the skin (photos IV page 3 : A - stomach,
B - back, C - arms, D - thighs, E - calf, F - back).
Move the belt slightly left or right (with device powered off) to feel the contractions on the abdominal area.
If an electrode hurts or if you feel any tingling, stop the device, and check the electrode is properly
smeared with cream.
TIP :
Fitting the full belt : To position the full belt at best, cross the 2 strips to flip the 2 ends on the outer scratch
part (photos V-A, B page 3).
Fitting the half-belt on the arm : Adjust at the belt mid-size, according to the outline of your arm before
positioning it, then start over if necessary to ensure proper adjustment (photos V-C, D page 3).
2 - Wire storage
unit is STOPPED
®
- 24 -
cream is applied.
®
® cream, please order directly by dialing
®
.
3 - Connection terminals 4 - Scratch strip