Breitling BENTLEY SUPERSPORTS B55 Manual Del Usuario página 32

• To launch a new rally, the rally in the memory must be erased by giving a long
press on P1 (erasing the times measured but not the target times – display
followed by ) or on P2 (complete erasing –
READy
defining a new one.
• Once the time has been introduced (
chronograph. The upper screen displays
stage), the lower screen the hours, minutes and seconds up to 99 hours, 59
minutes and 59 seconds.
• A second press on P1 stops the chronograph (
shows if the time is behind with regard to the objective,
LATE
or if one is within +/- 1 second of the target; the lag or advance is displayed
GOAL
on the lower screen in hours, minutes and seconds format HH:MM:SS.
This information is accompanied by a sound signal as follows:
1. A long beep if the time is within the target.
2. A short deep beep if the time is up to 10 seconds later or a high-pitched beep if
the time is up to 10 seconds earlier.
3. Two short deep or high-pitched beeps if the time is up to 20 seconds later or 20
seconds earlier respectively.
4. Three short deep or high-pitched beeps if the time is outside these limits.
It should be noted that in the event of a lag, a short alarm will sound when the
target time is reached.
followed by
EMPTy SET RLy
), pressing on P1 starts the
READy
xx (xx being the number of the
STAGE
). After this, the upper display
STOP
if it is ahead
EARLy
58
• A new press on P1 allows the following race/stage to be started. The upper
screen shows
ERASE
) and hours, 59 minutes and 59 seconds.
• This operation may be conducted until the number of predefined stages is
reached. Following this, nothing further with happen.
• In the event of being forgotten, the chronograph will stop automatically after
99 hours and show
c) Rereading a regularity rally –
Once timing is finished, pressing P2 automatically allows the following parameters
of the race to be displayed successively (3 seconds per display):
• The total time on the lower screen with the indication
screen.
• The date of the race (1
on the upper screen.
• The start time of the race (1
on the upper screen.
RGSTART
• The target time of the different stages on the lower screen with the indication
xx.
STAGE
• The measured time of the different stages on the lower screen with the
indication
xx+1 and the lower the hours, minutes and seconds up to 99
STAGE
.
OVF
mode
STAGE
st stage) on the lower screen with the indication
st stage) on the lower screen with the indication
xx.
ACTL
59
on the upper
RGRALLy
RGRDATE