Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Fabric Installation
13
With the Bow Assembly in position, locate the
Adjustable Spreader Bar.
Lock it in the up/straight position. Secure it by
inserting the steel pin through the hole of the
spreader bar-straight pin portion facing inside the
vehicle
See Figure 20
14
To loosen or tighten your soft top, locate the
adjustable sleeve on the Spreader Bar. Remove pin
and twist to tighten or loosen the soft top. Reinsert
pin after adjustment is made.
Note: Ensure to adjust the spreader bar equally on
both sides of the vehicle.
The adjustable bar can be used to keep your soft
top fabric tight in hot weather.
See Figure 21
15
Push the Spreader Bars up until they snap into
place. Reinsert locking pin.
See Figure 22
16
Start zipper on the side window about 6 inches.
Insert the plastic strip on the front of the side window into channel on the front support bow/door surround.
Insert the plastic strip on the bottom of the side window into the side Belt Rail .
Note: Start at front end of the strip and work along it to the other end. Close the horizontal and vertical
zippers on the side indow. Repeat this step for opposite side.
See Figure 23
Figure 20
Figure 21
Adjustable
Sleeve
Figure 22
Page 7 of 9
Publicidad
Tabla de contenido
