Installation - Remington REM-B300LT-F Manual Del Usuario Y Instrucciones De Operacion

NOTICE: This heater is intended to be used as a supplemental heating source. Use this heater along with
your primary heating system. This heater must not be used as a primary heat source. If you have a central
heating system, you may run that system's circulating blower while using this heater. This helps to circulate
the heat around your house.
WARNING
WARNING
front, top, or sides of the heater; in high traffic areas; or in windy or drafty areas.
CAUTION
operating the appliance where impurities in the air exist (tobacco smoke, aromatic candles, cleaning fluids,
oil or kerosene lamps, etc.), may cause walls to discolor.
IMPORTANT: Vent-free heaters add moisture to the air, which is beneficial. However, if this heater is installed
in areas without adequate ventilation, mildew may form from too much moisture in the air. See AIR FOR
COMBUSTION AND VENTILATION, pages
CHECK GAS TYPE: Be sure your gas supply is right for your heater. If the supply is not correct, do not install
the heater. Contact the place where this heater was purchased for a heater appropriate for your gas supply.
NOTICE: State or local codes may only allow operation of this appliance in a vented configuration. Check
your state or local codes.
©2017 Pinnacle Climate Technologies
A qualified technician must install the heater. Follow all local codes.
Never install the heater in a bedroom or bathroom; in a recreational vehicle; where
curtains, furniture, clothing, or other flammable objects are less than 36" from the
This heater creates warm air currents. These currents move heat to wall surfaces that
are next to the heater. Installing the heater next to vinyl or cloth wall coverings, or
8 through

Installation

10.
11 Vent-Free Gas Heater User's Manual