Wall Mounting - Remington REM-B300LT-F Manual Del Usuario Y Instrucciones De Operacion

WALL MOUNTING

WARNING
Mounting Bracket: The mounting bracket is packed in the same box as the heater but located seperately.
Methods for Attaching the Mounting Bracket to the Wall:
Use only the last hole on each end of the mounting bracket to attach the bracket to the wall. Attach the
mounting bracket to a wall in one of two ways:
1. Attaching to wall studs: This method creates the strongest hold. Insert the wood screws (4*16) through
the mounting bracket and into the wall studs.
2. Attaching to expansion bracket: This method allows you to attach the mounting bracket to solid walls
(concrete or masonry) or to hollow walls (wall areas between studs).
One method may be preferrable depending on where you install the heater,
but either method will provide a secure hold for the mounting bracket.
Marking Screw Locations:
1. Tape the mounting bracket to the wall where the heater will be
installed. Ensure the mounting bracket is level.
2. Mark the screw locations on the wall (See Fig. 11). NOTE: Mark only
the last hole on each end of mounting bracket. You will insert two (2)
wood screws (4*16) total through these holes only.
3. Remove the mounting bracket and tape from the wall.
Attaching the Mounting Bracket to the Wall:
NOTE: The expansion bracket, wood screws, and wall hanging spacers
are in the hardware package, which is provided with the heater.
Attaching to Wall Stud Method:
1. Drill holes at the marked locations using a 9/64" drill bit.
2. Place the mounting bracket onto the wall. Line up the last hole on
each end of the bracket with the holes drilled in the wall.
3. Insert the wall mounting bracket wood screws (4*16) through the
bracket and into the wall studs.
4. Tighten the wood screws until the mounting bracket is firmly fastened to the wall studs.
5. Before mounting the heater, check that the wall bracket is secure.
©2017 Pinnacle Climate Technologies
Installation (cont.)
ELECTRICAL, PLUMBING, OR GAS LINES MAY BE IN WALL.
Before cutting, drilling, or hammering, verify their location. If needed, contact your
electrician, plumber, or service person.
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this heater may result in property damage or personal injury.
WARNING
15
Fig. 11—Mounting Bracket
Clearances (Inches)
Min.
12"
B100 / B200 / R150 / R180
Only insert mounting
screws through last
hole on each end.
FLOOR
Min.
13"
B300 / R280 / R300
Only insert mounting
screws through last
hole on each end.
FLOOR
Vent-Free Gas Heater User's Manual
Min.
7 1/2"
Min.
17 1/2"