Instructions:
1 ) Check that the supply voltage must match the nameplate data.
2 ) Guard installation and adjustment:
Guard installation and adjustment The shroud is a protection device to prevent injuries due to broken wheels in the work. When
installing the shroud, match the protruding part of the shroud with the groove on the gearbox, then rotate the shroud
counterclockwise to the working position, and finally fasten the screws firmly.(Install according to the direction shown in the
figure, otherwise disassemble.)Before starting work, make sure the guard is installed and tightened. Slightly loosen the set screw,
the shield can be turned and fixed at theFrom the working point of view, after the shield is adjusted, make sure that the fixing
screws are fully tightened.
18
51311/05155
gear box cover
中文
EN
DE
RU
shielding
screw
KO
PT
JA
ES