Patient Instructions - Össur Miami Lumbar Instrucciones De Uso

2. Adjust the posterior and/or anterior panel as needed to achieve correct fit and positioning. The
rigid posterior panel should be centered on the spine with the bottom of the rigid posterior panel
at approximately the sacrococcygeal joint. The rigid anterior panel should be centered on the
abdomen with the bottom edge just above the symphysis pubis while still allowing the patient to
sit comfortably. (Fig. 9a and 9b)
3. Slide thumbs through the holes in the two compression system handles and pull until the brace
is at the appropriate tightness. For best results, re-tighten the compression system while patient
is supine.
BrACE rEMOVAL
1. Detach compression system handles slowly from the belt to loosen and attach them at the
original position. (Fig. 10)
2. Detach the overlapping closures and remove brace.
Note: To ensure a proper fit, be sure the compression system is stretched to its full width before
re-applying the brace. (Fig. 11)
BrACE ADJustMEnts
• The posterior and anterior rigid panels can be modified as necessary to optimize patient fit and
comfort. Simply remove the panels from their fabric sleeve and adjust the rigid panel with a heat
gun (350º F/175º C) and/or trimming device.
• The Miami Lumbar brace is a completely modular system and can be easily customized to the
needs of your patient. Rigid anterior and posterior panels can be added or removed depending
on the motion restriction and compression desired throughout the rehabilitation period.

PAtIEnt InstruCtIOns

• The patient should be instructed how to tighten and loosen the compression system while at
home. Simply have them slip their thumbs in the compression system handles and detach them
from the belt. At this point the handles can be pulled for a tighter fit or relaxed for a looser fit.
Caution: Do not over tighten the compression system to the point where it causes discomfort or
difficulty breathing.
• For sitting, the patient may find it desirable to slightly loosen the compression system.
Warning: If brace causes discomfort or irritation, contact your healthcare provider for further
instructions.
BrACE MAIntEnAnCE
The Miami Lumbar brace is designed for minimum maintenance and care. The padded covers may
be removed from the rigid panels for washing.
• Hand-wash using mild soap and rinse thoroughly.
• Air dry flat.
• Do not machine wash or place in tumble dryer.
ACCEssOrIEs
The following accessories are available for your Miami Lumber brace. To order, contact your
healthcare provider or your Ossur Customer Service Department.
• Posterior air bladder
• TLSO attachment
9