Installation (Hard Drive); Nvr Cabling - Atlantis TRIOX TX 400 Manual Del Usuario

 Remote controller (TX800/1600) without batteries (2 x AAA)
If any item contained is damaged or missing, please contact your local dealer as soon as possible.

1.3 INSTALLATION (Hard Drive)

Please do NOT install or uninstall hard drive while NVR is running.
 Loosen the screws in the left and right sides.
 Remove the cover
 Connect data cord and power cable.
 Install HDD (2,5" or 3,5" and up to 2TB) on the bracket, fixed with screws firmly.
 Check if the connectors are properly connected and there is no problem with wiring and close up cover, and
fix it with screws.

1.4 NVR CABLING

 Onvif IP Cameras
 Analog Cameras (900TVL)
 AHD Cameras (1 or 2MP)
 Connect a VGA/HDMI cord (not included) from your monitor to the VGA/HDMI output on the rear panel of
your NVR (or use RCA Output).
 Connect the USB mouse to the USB slot for mouse on the rear panel of the NVR.
 Connect one end of the network cable (not included) to RJ-45 port on the rear panel of the NVR.
 Connect another end of the network cable to your router, modem or other network connection device.

Plug in both of the Camera & NVR power supply to an open outlet.
The TRIOX models support, depending on the model, the AHD Cameras (analog high-
resolution up to 2MP) and standard analog Cameras.
The only care is to use two identical cameras in pairs (analog, AHD AHD 1MP or 2MP).
For example, the A15-TX400 model supports 4 BNC input. You can configure it in the
following ways:
• Ports 1,2,3,4 Analog Standard
• Ports 1,2,3,4 Analog AHD
• Ports 1,2 Analog AHD and Ports 3,4 Analog Standard
• Ports 1,2 Analog Standard and Ports 3,4 Analog AHD
Analog Standard
Analog HD
0
2
4
Analog Standard
Analog HD
0
2
4
6
8
10
12
14
16
IP
Analog Standard
Analog HD
8
0
6
2
2
4
6
8
IP
16
14
12
10
8
6
4
2
0
36
IP
16
6
4
2
0
ENG