AC Hydraulic VL3 Manual De Instrucciones página 3

VL3, VL6 & VL10
GB
WARNING -
safe usage instructions
1. The transmission jack is only to be used by trained
staff, familiar with this User's Guide.
2. The use of this jack is limited to removal, instal-
lation, and transportation in its lowest position, of
transmissions, transfer cases and transavles etc.
3. W ithin the weight limitations specified, the jack
may be used with the original adaptors.
4. Be sure that the vehicle is appropriately supported
and chocked before starting repairs.
5. This jack is designed for use only on hard level
surfaces capable of sustaining the load.
6. Avoid decentral gravity of the load. Decentral
placement of load might cause overturning of load
and transmission jack.
7. All transportation must take place with jack in the
lowest position and load stabilized.
8. Do not overload.
9. No alterations is to be made on the transmission
jack or the safety valve.
10. Failure to follow these warnings may result in loss
of load, damage to jack, and/or failure resulting in
personal or property damage.
Assembly
1. Mount the legs loosely by means of four bolts
2. Tighten the wheels to legs by means of bolts
3. Place jack on level surface to make pump rest on
two lowest bolts
bolts before tightening of two lowest bolts. Neg-
ligence of this procedure might make the jack
"3-legged".
4. Grease spike
(38)
accordance with drawing.
5. Grease end of pump piston
Use of Transmission Jack
Lifting: Operate pumping pedal
Lowering: Open release handle
slowly counterclockwise. The release handle is spring
activated and will close automatically when not acti-
vated.
Transport: Lower load to lowest position and check
stability of load before transport.
Maintenance
Daily: Check transmission jack for damages.
Monthly: Lubricate spike
pump piston .
(35)
. Tighten two through-going
(27)
and assemble pedal
(44)
.
(35)
(44)
by turning it
(40)
of pedal. Grease end of
(38)
Oil filling: Check oil level with lifting saddle
lowest position. Correct oil level is to lower edge of
hole for filling screw
lowest position.
Quantity of oil: 1,2 l. Any good hydraulic oil of
viscosity ISO VG 15 can be used.
Never use brake fluid.
Safety inspection
In accordance with national regulations - yet, at least
once a year - the following parts must be checked
by an expert:The lifting saddle, legs and wheels for
incipient breakage and unnormal wear. Hydraulic parts
for leaks. Function of excess-pressure valve.
Possible faults and how to overcome them
1. The transmission jack does not lift to maximum
height: Check oil level.
2. The pump is pumping badly (half strokes):
Vacuum has been created in reservoir because
of too much oil. Check oil level and empty out extra
oil.
3. The transmission jack lowers: Check whether the
release is closed tightly. If not tighten spring max
1/2 turn to the left.
Destruction
Oil must be drained off and legally disposed of.
(27)
.
(25)
. in
with transmission jack in its
(30)
(see "maintenance")
in
(36)