Recommended Cutting Equipment For Usa; Recommended Cutting Equipment For Canada; Kickback Information - Husqvarna 120i Manual De Instrucciones

Recommended cutting equipment for USA

Following is a list of recommended cutting equipment for Husqvarna cordless chain saw model 120i. This chain saw
model equipped with either of the listed guide bar and saw chain combination(s), fulfills the requirements according to
UL 60745-2-13.
Chain saw model Husqvarna 120i met the kickback performance requirements of ANSI B175.1-2012 when tested with
the combinations of bars and saw chains listed below. The saw chain Husqvarna H37/H38 is also classified as a low
kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B175.1-2012. We
recommend to use only the listed combinations of bars and chains for chain saw model Husqvarna 120i. Other chain
saw models may not meet the kickback requirements when equipped with the listed guide bar and saw chain
combinations.

Recommended cutting equipment for Canada

Following is a list of recommended cutting equipment for the Husqvarna cordless chain saw model 120i. The listed
combination(s) of powerhead, guide bar and saw chain meet all requirements outlined in Canadian Standards
Assosiation Z62.1-11 (Chain Saws) and Z62.3-11 (Chain Saw Kickback).
Furthermore the saw chain Husqvarna H37/H38 is evaluated and listed as a Type C Low Kickback Saw chain according
to the provisions in Z62.3-11.

Kickback information

The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
The following cutting attachments are approved for the model Husqvarna 120i.
Guide bar
Length, inch Pitch, inch
14 3/8
14 3/8
Note! Depending on your model version of Husqvarna 120i you must ensure that you combine the correct guide bar
and saw chain (0.050 gauge bar= H37 and 0.043 gauge bar= H38). The chainsaw will not function correctly with the
wrong combination of guide bar and saw chain.
''
32 – English
TECHNICAL DATA
Max. nose
Gauge, inch
radius
0.050 7T
0.043 7T
Saw chain
Type Drive link count
Husqvarna H37 52
Husqvarna H38 52