Ib10-S Applications; Tara; Normal Weighing Mode; Equipment Configuration - Baxtran IB10-S Manual De Instrucciones

6. IB10-S APPLICATIONS

6.1 TARA

6.2 NORMAL WEIGHING MODE

6.2.1 EQUIPMENT CONFIGURATION

6.2.2 FIRST CALIBRATION

6.2.3 USE

6.3 PIECE COUNTING MODE
6.3.1 EQUIPMENT CONFIGURATION
6.3.2 FIRST CALIBRATION
6.3.3 USE
6.4 LIMITS AND ALARM
6.5 MONO-RANGE / MULTI RANGE/ MULTI INTERVAL
6.1 TARA
Place a container on the platform, a value for its weight will be displayed. Press the key
displayed is stored as the tare value and that value is substracted from the display, leaving zero on the display. The
"NET" indicator will be on. As product is added only the weight of the product will be shown. The scale could be tared a second time if another
type of product was to be added to the first one. Again only the weight that is added after taring will be displayed. When the container is
removed a negative value will be shown. If the scale was tared just before removing
the container this value is the gross weight of the container plus all product that was removed. The zero indicator will also be on because the
platform is back to the same condition it was when the key
6.2 NORMAL WEIGHING MODE
6.2.1 CONFIGURATION OF THE EQUIPMENT
See section LF2 of the technical parameters
6.2.2 FIRST CALIBRATION
See section LF1 of the technical parameters
6.2.3 USE
Switch on the equipment when all the parameters have been correctly configured and the equipment has been calibrated
• Make sure than the value of the indicator, without load on the platform, is 0. If this is not the case, press
• Place the weight on the platform and the platform will show the weight.
• The accumulation and sending of data will depend on the mode chosen in the section UF-6
• You can display the accumulated values at any time by pressing
(Accumulation is only working with acive printprotocol)
6.3 PIECE COUNTING MODE
6.3.1 CONFIGURATION OF THE EQUIPMENT
See section LF2 of the technical parameters
6.3.2 FIRST CALIBRATION
See section LF1 of the technical parameters
6.3.3 USE
Switch on the equipment when all the parameters have been correctly configured. Make sure that the value on the visor, with no load on the
platform, is 0. If this is not the case press the key
STEPS TO FOLLOW;
1. Press the key
2. Press the key
C50/C100/C200.
3. Place the sample on the platform, and wait until the sign of stability and press the key
4. Place the product on the platform and the screen will show the number of pieces.
24
until the symbol PCS appears on the screen
successively to choose the quantity of pieces of the sample. On the screen will appear, successively, C10/C20/
was last pressed.
(TOTALIZING)
.
USER'S MANUAL IB10-S
to tare the scale. The weight that was
.
EN