Controller - FRICON CLS Uso Y Mantenimiento

SMR
7.1. Loading
For conservation and refrigeration equipment, before placing the products, the
equipment must be switched on and remain in operation until the desired interior
temperature is reached. After this time, the previously frozen or refrigerated products
can be loaded inside.
CAUTION
In the compartment designated for freezing products, frost burns may develop on
hands upon loading products into the equipment. The use of safety gloves is mandatory!
The equipment must be loaded up to the load limits indicated on the inside of the
equipment (see Fig.10).
In no case should the goods be loaded above the "Load Limit"; from that level the
storage temperature is no longer guaranteed, as well as the storage temperature of all
the equipment.

8. Controller

The appliances come with pre-set factory temperature settings. To activate manual
defrosting (if applicable) follow the instructions in this chapter, below.
NOTE:
•
All the instructions in this chapter refer to the standard control panel Carel IR33+
(Fig.11) used in the equipment. Nevertheless, there are other types of control
panels that may be used in the products. If that is the case please refer to the table
below.
Danfoss AD/ADVS
Dixell XWI70K
Carel IR33+ Controller
Controller
Fig. 11 - Carel IR33+ Controller
Fig. 10 - Load Limit
43
English
Page to search
Page 87
Page 89