Problem Resolution Guide - FRICON CLS Uso Y Mantenimiento

SMR
• You can only clean the inside of the lid with a soft cotton cloth moistened with
the following solution: 90% distilled water + 10% isopropyl alcohol and clean the
entire area. Cleaning products can destroy the coating.
• The outer part of the lid can be cleaned with normal cleaning products.
NOTES:
• Do not use hot water on glass doors while they are cold: the temperature
difference might break them.
• Do not remove fixed parts for cleaning. If necessary, they must be cleaned by
qualified personnel.
• Do not use hot water on glass doors while they are cold: the temperature
difference might break them.
Component Replacement:
If any component of the equipment is damaged, it must be replaced by personnel
qualified for this task.

10. Problem Resolution Guide

10.1. The equipment does not work
• Check if there is electrical current.
• Check if the plug is properly inserted in the source outlet and if the voltage and
frequency are appropriate for operation.
10.2. Unsatisfactory temperature
• Check if the equipment has been connected long enough to have reached
operation temperature.
• Check if the appliance is not near heat sources.
• Check if the doors are properly closed.
• Check the temperature regulation.
• Check if the products do not exceed the load limit.
• Check if the room and defrosting probe thermostats are turned on correctly.
• Check if the condenser fan is working.
• Check if the condenser is unobstructed.
10.3. Very noisy equipment
• Check if the equipment is placed on a leveled surface.
• Check if the vents are unobstructed.
• Check if the screws and nuts are perfectly fastened.
• Check if the cooling fan has any problems / does not work properly.
• Check if the compressor has any problems / does not work properly.
• Check if any of the condenser's support parts are loose / broken.
10.4. Light does not work
• Check that the light has power.
• Check that the light has been turned off by the timer (Carel controller).
50
English