FRICON CLS Uso Y Mantenimiento página 48

SMR
• Wash the interior with pure water, to which a little
neutral detergent may be added.
• To clean the defrost chute:
o Wet a cloth with a non-reactive cleaning
product to clean the defrost chute.
o To clean the corners of the defrosting chute a
brush is recommended.
• Finally, dry it with a soft cloth.
• Connect and wait for the appliance to reach
operational temperature again.
• Place the products inside.
• During defrosting some water may remain on the
bottom of the equipment, it is necessary to open the inner and outer cover to
remove the water (Fig. 12/13), using the fitting (Fig.14) placed on the outer cover
to facilitate the flow of water to the desired reservoir.
Fig. 12-Interior cover of the equipment
Cleaning the outside:
• Disconnect the equipment from the electrical current before cleaning the exterior
so that there is no risk of electric shock.
• Clean the equipment's exterior with a soft sponge soaked in warm water and
soap.
• Then clean it with a soft cloth and dry.
Fig. 14- Fitting placement illustration
Fig. 13- Outer cover
48
English