FRICON CLS Uso Y Mantenimiento página 49

SMR
• The
refrigerator
(compressor,
tubes, and remaining components) must
be cleaned with a soft brush or vacuum
cleaner.
• Pay special attention while cleaning the
condenser. If obstructed, it will affect the
equipment's performance.
• While cleaning, be careful not to twist the
tubes or disconnect cords.
• There are two types of water reservoirs:
o Cleaning the type A defrosting water tank:
(1) -Remove the drain pipe
(2) -Remove
evaporation.
(3) -Then remove the defrost water tank and clean it.
After cleaning it, place the tank in the same position.
(1) -First, place the hot gas tube inside the reservoir.
(2) Second, insert the drain pipe.
Everything must be in the same initial configuration.
1
• Cleaning the type B defrosting water tank:
1
Remove the reservoir as shown in figure 2.
After cleaning it, place the tank in the same position, as seen in figure 1.
Cleaning Glass Doors:
• Cleaning with abrasive microfibers cloths and all types of coarse sponges is
prohibited.
• Make sure to avoid large quantities of water from being applied on the glass
surfaces to be cleaned and that the surfaces are thoroughly dry afterwards.
circuit's
condenser, connection
the hot gas
2
2
exterior
NOT TO USE SHARP
OBJECTS NEAR THE
pipe for reservoir
3
49
English
CONDENSER.
1
2
3