NEC NP2000 Manual Del Usuario página 106

[Projector Name]
Specify a unique projector name. Press
characters can be used. After entering a name, select [OK] and press the ENTER button.
Using Software Keyboard
1 to 0 and
Characters ....... Use to type in password or keyword.
MODE .................... Selects one of three modes for alphabet and special characters.
SP ......................... Inserts a space
BS ......................... Deletes one character backward
.......................... Returns to the previous
.......................... Advances to the next
OK ......................... Executes the selection
Cancel ................... Cancels the selection
Selecting Communication Speed [Communication Speed]
This feature sets the baud rate of the PC Control port (D-Sub 9 Pin). It supports data rates from 4800 to 38400 bps.
The default is 38400 bps. Select the appropriate baud rate for your equipment to be connected (depending on the
equipment, a lower baud rate may be recommended for long cable runs).
Your selected communication speed will not be affected even when [Reset] is done from the menu.
Setting the Current Date and Time [Date, Time Preset]
You can set the current time, month, date, and year.
NOTE: The projector has a built-in clock. The clock will keep working for about 2 weeks after the main power is turned off. If the main
power is off for 2 weeks or more, the built-in clock will cease. If the built-in clock ceases, set the date and time again. The built-in
clock will not cease while in the standby mode.
Turning On or Off Remote Sensor [Remote Sensor]
This option determines which remote sensor on the projector is enabled in wireless mode.
The options are: front, rear or both.
to display the software keyboard and type in. Up to 16 alphanumeric
96
6. Using On-Screen Menu