Inserting And Removing A Pc Card - NEC NP2000 Manual Del Usuario

Inserting and Removing a PC Card

To insert the NEC optional wireless LAN card or a PC memory card (also referred to as PC card in this manual), follow
the steps below.
CAUTION:
* Direction for Inserting the PC Card
The PC card has a top and bottom and must be inserted into the PC card slot in a specific direction. It cannot
be inserted backwards or upside-down.
Attempting to force it into the slot in the wrong direction may break the internal pin and damage the card slot.
Refer to the PC card's operating instructions for the proper direction of insertion.
* Back up your PC card's data in case it will need to be restored.
* To prevent electrostatic discharge damage to the wireless LAN card, wear an anti-static wrist strap. If no wrist
strap is available, ground yourself by touching metal such as a door knob.
* Always insert or remove the wireless LAN card when the main power is turned off. Failure to do so may cause
projector malfunction or damage to the wireless LAN card. If the projector will not work correctly, turn off the
projector, wait 30 seconds, and turn it back on.
A dummy card is inserted into the PC CARD slot at the time of
shipment. First remove the dummy cards before use.
Inserting the PC Card
1. Make sure the main power is off before inserting the
PC card. (This step is needed only when the wireless
LAN card being inserted into the projector's PC CARD
slot)
2. Hold the PC card horizontally and insert it slowly into
the PC card slot with its top facing up.
The eject button pops out once the PC card is fully inserted.
Check that the PC card is fully inserted.
NOTE: Do not try to force the PC card into the slot or you may bend
the pins inside the slot.
2. Installation and Connections
PC card (not supplied)
21